Hogan Tent Stakes UK — Premium Marquee Stakes & Event Anchoring
Straight in. Straight out. Season after season.
Sole UK distributor for Hogan Tent Stakes — high alloy steel marquee stakes for hire companies, inflatable operators, and event production teams.
Explore Tiger Stakes Get in TouchSpecified for Professional Hire Work
Why high alloy steel outperforms commodity mild steel
Pole Marquees
Every stake is structurally essential. A medium marquee runs 60–75 large stakes. Pole Tent Staking Guide →
Clearspan Marquees
All load concentrates at base plates, with forces in multiple directions simultaneously. Clearspan Anchoring Guide →
Stretch and Sailcloth
Continuous dynamic tension at every anchor point, with high-load ridge and primary anchor positions. Stretch Tent Anchoring Guide → and Sailcloth Tent Guide →
Inflatables and More
EN 14960 compliance, PIPA inspection readiness, minimum 16mm diameter, 380mm length. EN 14960 Compliance Guide → and Bouncy Castle Wind Limits →
High Alloy Steel That Reaches Full Depth
In Stock
Tiger Stakes
Mill finish high alloy steel with Hogan's heat-drawn point. For lighter loads in firm to medium ground — pole marquee guy ropes, secondary anchors, and smaller inflatables. In soft or loose ground, the 36" or 42" will hold better.
Get a Trade Quote View Spec →
In Stock
Tiger Stakes
Mill finish high alloy steel with Hogan's heat-drawn point. The most widely used general-purpose size — reliable holding for pole marquees, stretch tent primaries, and medium-load anchor points in firm to medium ground. In soft or waterlogged ground the 42" will hold better.
Get a Trade Quote View Spec →
In Stock
Tiger Stakes
Mill finish high alloy steel with Hogan's heat-drawn point. For high-load anchor points — clearspan base plates, sailcloth primaries, and large marquee structures — and for soft or variable ground where the 36" won't achieve adequate pull-out load. The 29mm diameter gives roughly 10% more lateral resistance.
Get a Trade Quote View Spec →
In Stock
Tiger Stakes
Mill finish high alloy steel with Hogan's heat-drawn point. Maximum single-stake holding for large marquee and sailcloth primary anchors. The 1219mm depth matters most in soft or loose ground — more embedment, more holding. Also right when ground is variable and a 42" risks seating short.
Get a Trade Quote View Spec →
In Stock
Tiger Stakes
Mill finish high alloy steel with Hogan's heat-drawn point. For the highest-load structural anchors and deep soft or loose ground where shorter stakes can't reach reliable resistance. Not for obstructed or rocky ground — gang staking with shorter stakes is the right approach there.
Get a Trade Quote View Spec →Stakes Calculator
Used on Real UK Ground
"Yorkshire Limestone, where other pins gave us the banana treatment. The Hogans went in straight and came out the same way. Night and day."
"We put 80 stakes through a showground at the end of a dry August. Ground like concrete. Not one Hogan bent. Compare that to a job we did three months earlier with standard pegs — we had to cut four out."
"We were sceptical about price. Switched half our inventory last season to compare. The Hogans are still straight. The others... aren't. We won't be going back."
Talk to the Team That Uses Them
Stock, Pricing, and Specification Advice
If you are specifying stakes for professional hire work, tell us your structure type, expected quantities, and typical ground conditions. We will respond with practical guidance and a trade figure that reflects your requirements.
Get in TouchOperational Standards
References to BS EN 13782 and the MUTA Best Practice Guide reflect the standards we work to on our own events and recommend to every operator we supply. When you call us with a ground condition question, you are talking to people who have stood in the same field.
Get in Touch